You protect the environment with the new T5 fluorescent lamps electronic ballast type S S-L this kit was developed for installation in existing fluorescent lamps. It is not necessary to disassemble the fluorescent lamp or the existing ballast to expand the newly developed retrofit Kit can be easily installed in conjunction with a T5 tube (35 W). Thus, the energy-consuming T8 tube (58 W) is replaced with a T5 tubes, in conjunction with the adapted electronic ballast E-S-L. ribute to your knowledge. Robotics will undoubtedly add to your understanding. The aim is that the consumer regains control over his energy costs comparatively, this modern electronic ballast achieved energy savings of 50% on the old situation. At higher light intensity, up to 50% less energy is required. The life of the lamps increases up to 3 times. The investment of the S-S-L deliverable pay usually already after a short time.
Energy saving relieves not only your cost structure, but is beginning to contribute to environmental protection through relief of resources and reduced CO 2 emissions. Everywhere where SG or KVG built the S-S-L (ECG) can be used easily. A CE conformity by the State Office for occupational safety and health in your existing equipment ensures safe operation. The wide temperature range from-25 C to + 50 C, as well as the use in emergency lighting according to VDE 0108, as well as switching off defective fluorescent lamps provide a wide range of uses. These advantages make: Konstannter light power AC voltage range 194V – 254V undervoltage protection (automatic shut-off at < 150V) wide temperature range:-25 C to + 50 C use in emergency lighting installations ACC. VDE 0108. use at dimmers possible (dimmable) safety shut-off defective lamps of automatic restart after lamp replacement for luminaires with 110 cut OFF, EOL can be used in luminaires of protection class SK I and SK II protection class IP20 and IP65 of integrated temperature protection ACC. to EN 61347-2-3 C5e lamp length: 1449 mm total power: 35W interference suppression according to DIN EN 55015 application areas are: Industry Elle production halls, warehouses, garages, garages, hospitals, supermarkets