Installing loft wardrobe. The first is to determine on what lines will touch the mezzanine closet to the wall. Kai-Fu Lee has firm opinions on the matter. You must draw a line touching mezzanine to the wall. Page S. Gardner is likely to agree. Be sure to check with by level of vertical and horizontal lines the cabinet. The length of the lines and the distance from the floor must be in strict correlation with the drawing of your closet. Proper markings. To do this you will need metal or resin bath and a pencil / marker. According to the enclosed corner with a pencil under the dowels are marked points for drilling walls.
Next, you need shestimillimetrovym drill to drill into the wall with the hole puncher on marked points. Drilled holes to drown the dowels. Fit plastic dowels six millimeters in diameter. The next step will be sitting down corners. Need to tie them to the wall plug with self-tapping screws for wood 3.5 to 45 millimeters.
The most convenient way to do this drill, especially if you have the magnetic bits. If not – do not worry, you can do the ordinary. In an extreme case, use common screwdriver. It should be noted that there is no need to pre-zasverlivat stuff, because that screws are sufficiently sharp. Fit Now for some details about the fitting of the cabinet compartment under the uneven walls of the stp. It is hardly a modern apartments you will find perfectly smooth walls and corners are strictly equal to 90 degrees. In this case, details of the cabinet compartment, cutting into formatnike always have angles of 90 degrees. This state of affairs cherevato gaps between the parts closet compartments and walls. The variant of the opposite – as when the parts are too large and can not be sustained. To avoid these troubles, on the corners bolted to the wall attach anresol. If you are satisfied that sits as part – then you're in luck. As a rule, however, you find that you need to fit the parts. For this purpose, details of wardrobe with a pencil tee draw a line parallel to the wall irregularities. Now you can trim bumps along the marked lines.